Generally you will not get a proper reading on the compression from an
engine that has not been run in.
Kees Oudesluijs
NL
Jack Newton schreef:
> Do any of you list participants have a good estimate of the compression
> readings (psi) that one should get on a 4 cyl rebuilt 100-4 BN-1engine with
> new rings, pistons, valves, etc. Engine is just assembled with no break-in
> miles so far. Pistons are std 8:1 ratio with no competition or performance
> mods.
> TIA
> Jack
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> You are subscribed as coudesluijs@chello.nl
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|