It may be more convenient to replace them with tight fitting bolts with
a short cilindrical shaft and self locking nuts, after
redrilling/reaming the holes in the frame to the diameter of the bolts
shaft. Fit them with some graphite/MoS2 grease. Do not forget to fit
brass or nylon washers between the moving parts.
If you want to use rivets, you still have to redril/ream the holes as
they are likely to have worn as well. Rivets are still available in many
sizes, but you may have to search around a bit. Hardware
shops/Google/Ebay etc. You can always have them made up by a machine shop.
Kees Oudesluijs
NL
healeymanjim@hansencc.net schreef:
> a couple of rivets in the top framework on the bn6 are worn pretty bad. are
>these hardware store items or do some of the suppliers carry them? hjim
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|