Yes, we had to file the cotter pin quite a bit to get the pin all the
way in on two different sets
Jim
-----Original Message-----
From: healeys-bounces@autox.team.net
[mailto:healeys-bounces@autox.team.net] On Behalf Of Stephen Hutchings
Sent: Saturday, December 19, 2009 9:31 PM
To: healeys@autox.team.net
Subject: Re: [Healeys] Kingpins
Thanks for all the answers.
It sounds like the consensus is that the threaded fulcrum piece
should be tight and go in with a tap, the trick being to line up the
flat for the cotter pin properly. It sounds like I may have to file
the cotter pin so that it will go in far enough; has anybody else had
to do this?
Stephen, BJ8
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
You are subscribed as jimf@frakes-eng.com
http://www.team.net/archive
CONFIDENTIALITY NOTICE
The information contained in this e-mail is intended only for the use of the
individual or entity to which it is addressed and it may contain information
that is privileged or confidential. If the reader of this message is not the
intended recipient (or the employee or agent responsible to deliver it to the
intended recipient), you are hereby notified that any dissemination,
distribution, or copying of this communication is prohibited. If you have
received this e-mail in error, please notify us by telephone at the number
listed above or by return e-mail.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://www.team.net/archive
|