Allen,
The hundred latch hook is canted on a different compound angle than the 6
cylinder latch hook. In addition there were differences in the screws and
nuts. I don't think your fitting of the hooks will be a problem though as
long as you can match the angle of the hook end.
Rich
--------------------------------------------------
From: "Alan Seigrist" <healey.nut@gmail.com>
Sent: Thursday, April 29, 2010 10:00 PM
To: "allen c miller jr" <acmiller@mhcable.com>
Cc: "Healey List" <healeys@autox.team.net>
Subject: Re: [Healeys] TOP BOW CLAMPS 100-4'S AND 100-6'S
> Allen -
>
> I suspect the difference is that the 100 latches are use BSF / BA screws
> (it's mix and match if I recall) and likely the BN4 uses UNF.
>
> Alan
>
> '52 A90
> '53 BN1
> '59 Jag Mk IX
> '64 BJ8
>
>
> On Fri, Apr 30, 2010 at 9:37 AM, allen c miller jr
> <acmiller@mhcable.com>wrote:
>
>> Is there any dimensional difference between BN!/BN2 and BN4 hood clamps.
>> they
>> have different part #'s and prices with Moss, but appear to be the same.
>> I
>> am
>> fitting a vintage hardtop to my 100m and have to customize the mountings
>> anyway, so I would be inclined to use the less expensive 100-6 hardware
>> if
>> it
>> makes little difference. of particular interest is whether the later
>> clamps
>> fit to the 100-4's ball-shaped post studs. any thoughts appreciated.
>>
>> allen miller
>> bn2/m
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net
[demime 1.01d removed an attachment of type image/jpeg which had a name of
dendekker BN1 006.jpg]
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|