I must disagree. On all drive shafts I have seen the yokes are paralell
to each other. That is also the theory otherwise you cannot have a
constant velocity for the in and out going shaft.
Kees Oudesluijs
NL
David Nock wrote:
> All driveshafts will be the same no matter if there are 2 or 3
> Universals in the shaft. The driving member at each end of the
> driveshaft must be at 90 degrees to each other.
>
> Originally on all British cars there is an arrow stamped in the
> sliding yoke, these should be aligned if the driveshaft is original.
> If they are not there then look at the driving member on the front
> yoke and the driving member on the rear yoke. They should be at 90
> degees to each other.
>
>
> David Nock
> British Car Specialists
> Stockton Ca 95205
> 209-948-8767
>
> www.britishcarspecialists.com
> .
> .
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|