You should contact "Rocker Arm Specialist" email = rocker@c-zone.net. He
is in Anderson, CA. He has done at least 4 for me, and they are very good
quality. ph = 1-530-378-1075.
John Snyder
----- Original Message -----
>I purcased a replacement rocker shaft assembly for my BJ8 due a bit lower
>than
> normal oil pressure, oil in the rear air cleaner and squirting up from a
> couple of the rocker arms. What is the suggested torque for the rocker arm
> nuts? I know to be careful about applying too much torque to the oil
> supply
> line. Can I re-use the copper washers on either side of the banjo fitting,
> or
> do I need to get new ones?
>
> Thanks!
> David Z.
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|