re: " Could one use masking tape to wrap the coils? If not what material
should be used."
I just used some silicone tape called 'Xtreme Tape' or something like that
(Moss sells it). It stretches and bonds to itself. Think it would work well in
this application.
re: "Would I fry the coil by using a 1.7 volt zinc plating wand to plate
the screw terminals?"
PROBABLY not; the relays on Healeys are meant for 12V. Note emphasis on
PROBABLY.
bs
--------------------------------
Bob Spidell - San Jose, CA
----- Original Message -----
From: "john spaur" <jmsdarch@sbcglobal.net>
To: healeys@autox.team.net
Sent: Saturday, August 14, 2010 8:04:20 PM
Subject: [Healeys] Coils inside relays
Could one use masking tape to wrap the coils? If not what material
should be used.
Would I fry the coil by using a 1.7 volt zinc plating wand to plate
the screw terminals?
Thank you,
John Spaur
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/bspidell@comcast.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|