.002in should be no problem for a gasket to overcome. Where did the gasket
fail? Was it where you notice the low spot? Which side, if you can tell,
head or deck?
dave
frogeye@porterscustom.com
Porter Customs 2909 Arno NE
Albuquerque, NM USA 87107
505-352-1378
1954 BN2 1959 AN5
Porter Custom Bicycles
cars:
www.britishcarforum.com/portercustoms.html
gallery:
http://picasaweb.google.com/porterscustombicycles/PorterCustomBicyclesStuff
blog: http://porterbikes.com/
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of T+ B Willig
Sent: Saturday, September 18, 2010 1:12 PM
To: healeys@autox.team.net
Subject: [Healeys] Is this 100 head warped??
Hello,
I was facing the typical problem of a blown head gasket since last week
(overheating, emulsified engine oil), so I decided to remove the new DW alu
head again. After cleaning the mating surface, I checked it with a
straightedge. Between the second and the third cylinder there is a small gap
under the straightedge were I can pass a 002 (0,05mm) feeler blade. Do you
think that I should send the head away for surface grinding, or is this
within tolerances?
Regards
Thomas Willig
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/frogeye@porterscustom.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|