As I was removing the axle bearing hub retaining nut I noticed that
the nut on the right side was further in that the nut on the left
side. It was about 1/4" There were no missing parts and the bearings
and bearing spacers are all the same thicknesses.
What might cause this?
TIA,
John Spaur
'62BT7
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|