I thought so,
Thanks
Ira Erbs
Digs 4 Solutions
Computer Consultants
Portland, OR
On Dec 1, 2010 6:23 PM, "Bob Spidell" <bspidell@comcast.net> wrote:
> The ones on our (mostly) original BN2 were bent over. Exposed wire was
just long enough to be bent back and almost
> reach the base of the connector.
>
> bs
>
>
> On 12/1/2010 4:38 PM, I Erbs wrote:
>> Tail light wire bullets. Are the wires soldered on the end or bent over.
>> Memory says bent. If bent how long should exposed wire be?
>> Ira Erbs
>> Digs 4 Solutions
>> Computer Consultants
>> Portland, OR
>> _______________________________________________
>> Healeys@autox.team.net
>> Donate: http://www.team.net/donate.html
>> Suggested annual donation $12.75
>> Archive: http://www.team.net/archive
>> Forums: http://www.team.net/forums
>> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/bspidell@comcast.net
>>
>
>
> --
> *******************************************************************
> Bob Spidell San Jose, CA bspidell@comcast.net
>
> *******************************************************************
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/eyera3@gmail.com
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|