The two through holes are to drift the bearing off the stub axle with a
small round shank drift punch.
Rich
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Robert Bender
Sent: Monday, December 27, 2010 9:39 PM
To: healeys@autox.team.net
Subject: [Healeys] BJ7 brakes, front suspension
I'm in the process of rebuilding the front suspension of my BJ7, and I would
like to know if anyone has any recommendations for high temp caliper/disk
paint that will hold up?
On a side note, I was surprised to find that the lower trunnion's fulcrum
pin
is designed so that the threads (3/4-12) act as the bearing surface as the
lower links rotate, and that the cork washers compress and expand with each
bump in the road. Not what I expected, though it seems to work just fine.
Last, I am wondering why there is a blind hole drilled into the back side of
the swivel axel, and what is the purpose of the two through holes on either
side of it.
Bob
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/richchrysler@quickclic.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|