I should have known it was correct; it was made by Heritage.
Thank you Peter and Rich for the information!
Rich added:
That shape is correct. The wider portion goes toward the front and it is
pulled down and sewn to the tunnel carpet.
At 08:41 PM 1/23/2011 -0500, you wrote:
>John,
>
>Yes, those dimensions are correct. The wide end goes to the front.
>
>For location on the tunnel carpet, the front edge of the armrest pad sits 1
>3/4" back of the ashtray. The left side of the pad is 1/4" from, and parallel
>to, the seam joining the two tunnel carpet pieces. This means the centreline
>of the middle pleat does not line up with the centre of the ashtray, but is
>offset to the right a bit.
>
>By the way, the original pads were only 3/4" thick Dunlopillo foam rubber, not
>the 1" or even more often seen in kits.
>
>Best regards,
>Peter
>Concours Advisory Committee
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|