healeys
[Top] [All Lists]

[Healeys] Insulation

Subject: [Healeys] Insulation
From: pajtamuvek at gmail.com (Austin Healey)
Date: Mon, 30 May 2011 07:23:21 +0200
References: <CA056E01.C8F7%tjmorrio@colby.edu> <BANLkTimDMm5YgG6DQDgt3pzLuhX7rbeuhg@mail.gmail.com> <BANLkTikweowjwmcGRbM9kG+8-e5EdR7UJg@mail.gmail.com> <BANLkTi=khzcGhzsPkLtjfS+Kun1RsvX_+w@mail.gmail.com>
Good uck Ira!

Gergo

2011/5/30 I Erbs <eyera3 at gmail.com>

> Almost,
> My engine has about 35k on it over the last 35 years. Waiting to restart
> mine, with newly rebuilt HD8 Carbs.  Hopefully two weeks out to restart.good
> luck with your initial startup.  The machine shop did a fast job.
>
> Ira Erbs
> IT Consultant
> Portland, OR
>
> sent from my Droid, please excuse typos and random self corrections because
> my phone has It's own ideas about what word I meant to write
>
> On May 28, 2011 11:33 PM, "Austin Healey" <pajtamuvek at gmail.com> wrote:
> > I am in about the same situation. Engine, transmission in, new loom
> wiaiting
> > to be installed.
> >
> > Gergo
> >
> > 2011/5/28 I Erbs <eyera3 at gmail.com>
> >
> >> Would like to see some photos,
> >> I still need to bolt down my tranny mounts and drive shaft. New wire
> >> harness
> >> this weekend, carbs back in two weeks, then hook up and restart car for
> >> first time in 20 months, when we started this project. Still lots to do,
> >> but a lot has been completed.
> >> Good luck with recovery. Do your exercises
> >>
> >> Ira Erbs
> >> DIGS-4 Solutions
> >> Portland, OR
> >>
> >> sent from my Droid, please excuse typos and random self corrections
> because
> >> my phone has It's own ideas about what word I meant to write
> >>
> >> On May 27, 2011 12:04 PM, "Thomas Morrione" <tjmorrio at colby.edu> wrote:
> >> > Ira b9 fwiw b9 I put my grommets in after I put on durmat and the
> >> tarpaper.
> >> It
> >> > worked ok in all but two of the cases where I didnB9t cut holes quite
> >> large
> >> > enough b9 suggest just eyeball it and see if thereB9s any likelihood
> that
> >> > youB9ll not be able to put the grommet in without more trimming. I did
> >> put
> >> > the couple of balk gromment/plugs in before I put on the duramat.
> Forgot
> >> > which those were though. Have just had knee replacement last week and
> am
> >> > laid up or would go look further.
> >> >
> >> > Have enjoyed your chronicle of rebuild b9 am about to put in redone
> >> > engine/trans/od this summer and move my project along/
> >> >
> >> > Best,
> >> > Tom
> >> _______________________________________________
> >> Healeys at autox.team.net
> >> Donate: http://www.team.net/donate.html
> >> Suggested annual donation $12.75
> >> Archive: http://www.team.net/archive
> >> Forums: http://www.team.net/forums
> >> Unsubscribe/Manage:
> >> http://autox.team.net/mailman/options/healeys/pajtamuvek at gmail.com

<Prev in Thread] Current Thread [Next in Thread>