Jonas, the fabric "curtain" is wrapped around the metal bow and glued to it.
I used contact cement to hold it and wrapped the fabric as tightly as I
could around the bow.
Steve Byers
HBJ8L/36666
BJ8 Registry
Havelock, NC USA
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of Jonas Payne
Sent: Friday, June 17, 2011 5:43 PM
To: Jonas Payne; healeys@autox.team.net
Subject: Re: [Healeys] BJ8 Top Question
Subject: BJ8 Top Question
Working on the top and have a question about how the top attaches to the
rear most bow.
There are 2 pieces of fabric attached to the top that are supposed to
form a "loop" around this bow.
On the top I took off, this fabric was glued to the bow.
If it doesn't glue, how tight should the loop be, and how do you hold it
in place while you struggle with the metal "u" that goes over the top of
it and screws to the bow?
Jonas Payne
PBR
Cell: (702) 358-5084
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|