You could also try a thread file on the shaft.
Magnus Karlsson
Sweden
www.concourshealeys.com
22 jun 2011 kl. 19.25 skrev I Erbs:
> My main issue is not sure I found the right nut for the wheel. It is big
> enough, but seems to be the wrong thread as it only goes on a couple of
> threads and then cocks over a few degrees. I'll keep looking around my
> garage fro another similarly sized nut and see what happens.
> Thanks for the ideas.
>
> 2011/6/22 Oudesluys <coudesluijs@chello.nl>
>
>> You could use a fine thread file to tidy up the thread.
>> Kees Oudesluijs
>> NL
>>
>
>
>
> --
> Ira Erbs
> IT CONSULTANT
> Portland, OR
>
> We can't solve problems by using the same kind of
> thinking we used when we created them.
> -Albert Einstein
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/magnuskarlsson@bornet.net
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|