Gergo -
If you aren't showing the car, just get a rubber or copper
bolt-expansion plug from your local auto supplier and bolt it in.
Alan
On 6/30/11, Austin Healey <pajtamuvek@gmail.com> wrote:
> Hi Friends,
>
> I am after a 100 miles of pure fun. Unfortunatly the rain stoped the fun
> this time also. Even more miserably this time the sky was bright and the
> rain pured from my engine. Umho. After shuting the negine off I have found
> that one of my core plugs have gone.
> Since it is the 2.7 engine with the "doomed" type plugs, I had quite some
> bad feelings of theese plugs. Is there an "appropriate science" how to
> install them? I have applied some sealand and pundhed the center of the
> plugs until they became a bit "flat" on the center. Did I do it wrong?
> Other than that the car ran marvellous. I have found a working set of
> distributor springs, soo now the power curve is fine, the hesitation and
> vibration went away from the low-range. Only I found the vacuum advance a
> bit too much. I will decrease that and the car will be spot on.
>
> Gergo
> _______________________________________________
> Healeys@autox.team.net
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com
>
--
Sent from my mobile device
_______________________________________________
Healeys@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|