healeys
[Top] [All Lists]

[Healeys] Oil routing in engine

Subject: [Healeys] Oil routing in engine
From: bspidell at comcast.net (Bob Spidell)
Date: Tue, 16 Aug 2011 18:26:01 -0700
References: <SNT143-W100FDD949C68F92576AAE2D4290@phx.gbl>
It's simple.  Oil goes in a hole in the valve cover and comes out from the 
front and rear mains, the pan gasket, the 
valve cover, the carburettors, etc.

Bob


On 8/16/2011 3:29 PM, S and T Miller wrote:
> I have never seen a diagram of the 6 cyl Healey engine oil passages.  Is it
> oil pump, pressure relief valve, oil filter, rod/ main bearings, cam bearings,
> rockers, drain to tappets?  Are there any branch out points or is it a direct
> run?  Where is the pressure gauge line in the run?  Just curious.
>
> The Millers
> "British Car Nuts"
>
> 1957 Austin Healey 100-6 BN4 35299
>
> 1959 Austin Healey 100-6 BN4 77219
>
> 1964 MGB 40841
>
> 1960 Austin Healey Bugeye Sprite AN5 34351
>
> "Always drive them, but remember each drive in an antique car is a test
> drive."
> _______________________________________________
>
>


-- 
*******************************************************************
Bob Spidell           San Jose, CA            bspidell at comcast.net

*******************************************************************

<Prev in Thread] Current Thread [Next in Thread>