Bob makes a very good point.
If there was rust in the tank, then what ever coating there was to
prevent rusting,(tin or zinc), has been compromised and without
treatment will rust in the future, particularly with our alcohol
enhanced(:-( ) fuel.
John
64/66 BJ8s
On 11/27/2011 1:15 PM, Bob Spidell wrote:
> Then apply a good gas tank sealant. I've had the Bill Hirsch product
> in the BJ8 for over 20 years with nary a problem (on what passes for
> gasoline in California, to boot).
>
> Bob
>
>
>
> On 11/27/2011 9:56 AM, Jackson Krall wrote:
>> At Home Depot you should find "Phosphoric Prep and Etch" by
>> Klean-Strip in the paint dept. and "Metal Prep Dip Rust Remover" by
>> Zep in the cleaner and chemical isle over near the chainsaws.
>> Best
>> JK
>>
>> On Sun, Nov 27, 2011 12:34 PM EST Ron Ray wrote:
>>
>>> Folks,
>>>
>>> A friend has his relative new Bugeye fuel tank repaired and now has
>>> a light
>>> coat of "flash" rust on the inside.
>>> Is the Moss fuel tank cleaner (part number 220-620) the most
>>> practical way
>>> to remove this light rust coating, or is there a simpler less expensive
>>> process?
>>>
>>> Thanks,
>>> Ron
>>> _______________________________________________
|