Probably not kosher with the pros, but if all else fails you can use a 'pickle
fork' under the heads of the pins. It'll
bend the flatwasher on the pin a bit, but they can be flattened and reused.
Bob
On 3/17/2012 12:32 AM, Patrick and Caroline Quinn wrote:
> G'day
>
>
>
> It's been close to 35 years since I dismantled the front suspension of my
> Austin-Healey.
>
>
>
> Almost done with just the lower wishbone arms to go, but I am wondering
> about removing the fulcrum pins.
>
>
>
> Easy to undo the castellated nuts, but what is the best way of levering the
> pins out as there is so little room, especially with the front shroud in
> place?
>
>
>
> The workshop manual is really useful stating "With the suspension unit
> supported, remove the fulcrum pins securing the lower wishbone arms to their
> brackets on the frame, taking care to retrieve the two rubber bushes and
> special washers from each bearing."
>
>
>
> Any advice would be appreciated.
>
>
>
> Hoo Roo
>
>
>
> Patrick Quinn
>
> Sydney, Australia
> _______________________________________________
>
>
>
--
*******************************************************************
Bob Spidell San Jose, CA bspidell at comcast.net
*******************************************************************
|