Thanks. My only existing plug is on my car. I hate to lose all my fresh
oil. I did try to anneal the existing washer without much success. That's
why I am going to try to do a quick switch with my finger in the dike so to
speak.
Ron
----- Original Message -----
From: "john spaur" <jmsdarch@sbcglobal.net>
To: "Ron Fine" <RonFineEsq@earthlink.net>
Cc: <healeys@autox.team.net>
Sent: Friday, April 27, 2012 11:41 AM
Subject: Re: [Healeys] Oil plug washer
25/32" ID, 1-3/32 OD, .06 thick. Take your plug down to the hardware
store.
John
At 06:03 PM 4/27/2012 +0000, Bob Spidell wrote:
I think it's 3/4" ID (hopefully, someone can un/confirm).
Or, you can just anneal the one you have: heat it to 'cherry red' with a
propane torch and let cool. Will seal as good as new.
Bob
--------------------------------
Bob Spidell - San Jose, CA
----- Original Message -----
Can someone give me the dimensions for the copper washer used to seal the
oil
drain plug on BN7? I need a new one and don't have time to order from
Moss.
I assume I can get one of the proper size locally.
Thanks,
Ron Fine
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/jmsdarch@sbcglobal.net
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|