Re: [Healeys] Cork washers for king pins, front springs install.

[Michael Salter <michaelsalter@gmail.com>]

Hi Todd,
The later and currently available kits just use a standard sized O ring.
A couple of 6" sections of 3/8" threaded rod can be used to pull the spring
plate up.

-- 
Michael Salter

        Check My Blog
http://www.netbug.net/blogmichael/

On Sat, Apr 28, 2012 at 6:00 PM, Todd Taylor <ttaylor33@twcny.rr.com> wrote:

> wondering if there is a source for Cork washers that go on the neck of the
> king pins.
> Or is there something else I can use like nylon type.  any one know what
> size they have to be??
> I hate to put an order in for 2 washers and pay $6 in shipping...   I
> assume they are used to seal up grease.
>
>
> also I have to put my front springs in , any ideas to do this??   my motor
> is out and there isn't any weight to work with.
> jack on the bottom will jack up the whole frame??     any specail tools?
>  spring compressor wont go up the center
> because there isn't any holes to go through..
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys

Unsubscribe/Manage: 
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net