Sorry for the error on my part ..... must have been a senior moment!!! many
thanks for the instructions. Don
----- Original Message -----
From: "Bob Haskell" <rchaskell at earthlink.net>
To: "Alan Grossman" <agrossman at pacific.net>
Cc: "Healey" <Healeys at autox.team.net>
Sent: Sunday, May 13, 2012 11:39 AM
Subject: Re: [Healeys] dwell
> Dwell is the period, measured in degrees of distributor rotation, that the
> points are closed. If you increase the point gap, the points will be open
> for a longer period, meaning the dwell will be shorter.
>
> For a 6 cylinder, the dwell should be on the order of 30-35 degrees; for a
> 4 cylinder, somewhere around 45 degrees.
>
> The factory workshop manual I have doesn't give dwell, but gives the
> points gap to be 0.014-0.016".
>
> Cheers,
>
> Bob Haskell
> AHCA 3000 Mk I registrar
> http://www.ciahc.org/registry_3000mk1.php
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys at autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/dpaye at crocker.com
|