healeys
[Top] [All Lists]

[Healeys] gap

Subject: [Healeys] gap
From: healeyguy at bredband.net (Per Schoerner)
Date: Sun, 27 May 2012 01:54:03 +0200
References: <20120526151740.A87D22D044A@autox.team.net>
Hi
I'd say it depends on how much you want the engine to rev when you 
enrichen the carburettors, e.g. use the choke.

Per in Sweden

healey.nut at gmail.com skrev 2012-05-26 17:15:
> There's no real set here because it depends on how the throttle shaft has 
> been drilled.  Usually, however, I back off touching the lever by about one 
> full turn (after slow idle fully set).
>
> ------Original Message------
> From: Dr. C. Rubino
> Sender: healeys-bounces at autox.team.net
> To: healeylist
> Subject: [Healeys] gap
> Sent: May 26, 2012 22:54
>
> What size should the gap be between the fast idling screw and the throttle
> shaft lever?

<Prev in Thread] Current Thread [Next in Thread>