The last time that I did this, I used circlip pliers and a friend pressing
down with the screwdriver. Snapped right in -- no problem. I had bought the
circlip pliers several years earlier just to say I had them. Smart
investment. Probably will never use them again but sure saved me having my
wife come out to the garage to tell me to lower the volume or clean up my
rant.
John Sims, BN6
Aberdeen, NJ
www.healey6.com
-----Original Message-----
From: healeys-bounces@autox.team.net [mailto:healeys-bounces@autox.team.net]
On Behalf Of andy pole
Sent: Tuesday, September 04, 2012 10:14 AM
To: ardmorebusiness@xtra.co.nz; frogeye@porterscustom.com;
tomfelts@windstream.net; healeys@autox.team.net
Subject: Re: [Healeys] Advice------BJ8 shift lever spring circlip
installation
Mark
You must have very strong fingers to squeeze the circlip tabs, thats the
problem, trying to squeeze the circlip closed and then hold it square while
using a flat screwdriver on the opposite side, then push the whole lot down
square whilst the spring is trying to overcome your vain efforts. The washer
doesnt make to much difference in the battle of wills.
Us girly brits must not be bred like the real men of nz (sorry tongue in
cheek).
Only advice is a good pair of circlip pliers, and maybe another pair of
hands on the screwdriver.
regards Andy
$12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://autox.team.net/mailman/options/healeys/ahbn6@verizon.net
_______________________________________________
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|