i never install a new exhaust hanger until i drill a 1/4 inch hole all the way
through the steel and rubber and put a 1/4 bolt through and tighten the nut
until it just touches the steel then peen it over so the nut will not come off.
this leaves enough room for the rubber to flex but it does not seperate. an
extreme shock will be taken up by the bolt. have had them both cars for years
with no problems of separation. works for me.
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|