Charlie
The transmission tunnel is held in place by the screws that attach it to
the floor. The front flange is covered on both sides by the vinyl. There
are no screws in it.
The carpet is attached to the tunnel by four snaps and should extend to the
edges of the floor flanges. The floor carpets then lie over the carpetted
tunnel flanges.
Derek
On Thu, Jan 24, 2013 at 2:35 AM, Charlie Schott <schottc@knology.net> wrote:
> Would someone please tell or show me how the carpet and vinyl is fitted to
> the front part of the transmission tunnel on a BT7. I've seen pictures
> where vinyl covers the flange part of the tunnel, but I don't know if the
> screw heads are on top of or below the vinyl. Also, does the vinyl fold
> over the flange or is it trimmed flush with the edge of the flange? That's
> assuming that screws are used to attach the tunnel to the shroud. Also,
> since the floor carpet is not permanently attached, am I correct in
> assuming that it goes on top of the tunnel mounting flange? And also the
> padding? Thanks in advance for your help.
>
> Regards,
>
> Charlie Schott
> ______________________________**_________________
> Support Team.Net
> http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/**listinfo/healeys<http://autox.team.net/mailman/listinfo/healeys>
>
> Unsubscribe/Manage: http://autox.team.net/mailman/**
> options/healeys/derek.c.job@**gmail.com<http://autox.team.net/mailman/options/healeys/derek.c.job@gmail.com>
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|