I can't get the fifth and ninth tappets out of the BT7 block (they're the
ones that are only about 1/2 exposed by the access holes). They come up
about 1/2 way and then impinge on the block. Is this normal (crumby MOWOG
casting)? Do I just wait 'til I remove the bottom end and push them down (
and install them from the bottom before the cam goes back in)? I'm
reluctant to force them or relieve the block.
Cheers,
Mike Tobin
BTW never got a response on finding oil under the head gasket - anyone have
any ideas on that?
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|