This is not entirely correct. I should have said: if the deviation is a
constant sector/distance.
Kees
Op 13-6-2013 2:36, Oudesluys schreef:
> If it is a constant 25-30 degrees of you can lift of the needle and
> reposition it on the spindle.
> To do so remove the entire assembly from the car, taking great care
> with the capillary tube, remove bezel and glass, and then lift of the
> hand/needle/pointer with two small screwdrivers under the centre and
> resting on the rim of the gauge. Insert the bulb at the end of the
> capillary tube in boiling water leave it for a few minutes and then
> reposition the needle pointing to 100 degrees C or 212 degrees F and
> press down.
>
> It the deviation is not constant you may have to adjust the small U
> shaped section between the bourdon spring and gear.
>
> Kees Oudesluijs
> NL
>
>
> Op 13-6-2013 1:09, Steve Gerow schreef:
>> Does anyone know if it's possible to move the temp gauge pointer? Or
>> is it
>> extremely fragile like the gas gauge pointer?
>>
>> My gauge is 25-30 degrees high and would like to adjust it back down.
>>
>>
>> --
>>
>> Steve Gerow
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|