Run a couple of very long bolts on the A-Arm plate (in opposing corners)
and de stress the spring by letting it down a bit, then try again, that
should work.
On Sun, Jun 16, 2013 at 7:24 AM, Patrick & Caroline Quinn <
p_cquinn@tpg.com.au> wrote:
> G'day
>
>
>
> No doubt we all know about the 2in blocks that should be placed under the
> front shock absorbers arms when an Austin-Healey is off the ground.
>
>
>
> Well yesterday I refitted the front springs to the BN3. Apart from having
> lots of fun lining up the holes for the bottom spring plates and the
> wishbone arms, it all went well.
>
>
>
> However it was when I was half way through when I remembered about the 2in
> blocks. So one side has the block and on the other the shock arm is
> pressing
> down hard on the new rebound rubber.
>
>
>
> Normally it would be a simple matter of just placing the trolley jack under
> the spring plate and lifting it up, but there is no engine in the car and
> all that happens is that the whole front of the car just lifts.
>
>
>
> Any suggestions? Apart from getting a couple of burly blokes to stand on
> the
> chassis rail I can't think of what to do. No I do know want to take the
> spring out and start again.
>
>
>
> Hoo Roo
>
>
>
> Patrick Quinn
>
> Blue Mountains, Australia
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/healey.nut@gmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|