healeys
[Top] [All Lists]

Re: [Healeys] Steering column issue

To: richard mayor <mayorrichard@hotmail.com>
Subject: Re: [Healeys] Steering column issue
From: john spaur <jmsdarch@sbcglobal.net>
Date: Mon, 30 Sep 2013 19:30:39 -0700
Cc: healeys <healeys@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
References: <BAY173-W4241C43201513818B5FC4BC0150@phx.gbl>
2. Use silver solder because if you powder coat the box it has a 
higher melting point than regular solder. It would ideal to have a 
melting point greater than 450F. You can use a propane torch with 
MAPI gas. Clean well, tin the tube, use plenty of flux, assemble and 
heat until the solder is drawn into the fitting.

1. You might need a mandrel and press to put the groove into place. 
You might be able to solder a washer in the tube to act as a seat or 
use cooper wire solder in place.

John

At 01:31 AM 10/1/2013 +0000, richard mayor wrote:
>I am rebuilding a steering box/column.  It had been in an ugly encounter
>sometime in it's life and the bottom of the tube, where it goes into the box,
>was buckled.  I applied massive heat to the box to melt the solder with my oxy
>torch in order to remove the tube. I have some new tubing, bought from a local
>source, that has the same OD and wall thickness.
>
>Here are my questions:  (1)  I need to swage a groove around the upper end of
>the tubing to retain the 2" felt bushing at the top of the column.  Any ideas
>on how to do this?   Or, is there another way of keeping the felt bushing in
>place...at the top of the column?
>(2)  Any tips on sweating the new column into the box.  I have experience
>doing this with 1/2" and 3/4 " copper fittings but not with sweating a steel
>tube into a big cast iron steering box.  Any tips?
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>Suggested annual donation  $12.75
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>
>Healeys@autox.team.net
>http://autox.team.net/mailman/listinfo/healeys
>
>Unsubscribe/Manage: 
>http://autox.team.net/mailman/options/healeys/jmsdarch@sbcglobal.net
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


<Prev in Thread] Current Thread [Next in Thread>