Richard,
I need to do the same thing with a non-adjustable box I have (all
replies to the list please!). I'm planning on making a two-piece
die/mandrel for the ID and heat the tube up. Then use a reworked air
chisel (without the air tool) to form it.
FWIW,
Bob Haskell
AHCA 3000 Mk I registrar
http://www.ciahc.org/registry_3000mk1.php
On 09/30/2013 09:31 PM, richard mayor wrote:
> I am rebuilding a steering box/column. It had been in an ugly encounter
> sometime in it's life and the bottom of the tube, where it goes into the box,
> was buckled. I applied massive heat to the box to melt the solder with my oxy
> torch in order to remove the tube. I have some new tubing, bought from a local
> source, that has the same OD and wall thickness.
>
> Here are my questions: (1) I need to swage a groove around the upper end of
> the tubing to retain the 2" felt bushing at the top of the column. Any ideas
> on how to do this? Or, is there another way of keeping the felt bushing in
> place...at the top of the column?
> (2) Any tips on sweating the new column into the box. I have experience
> doing this with 1/2" and 3/4 " copper fittings but not with sweating a steel
> tube into a big cast iron steering box. Any tips?
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/rchaskell@earthlink.net
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|