healeys
[Top] [All Lists]

Re: [Healeys] fuel gauge calibration

To: john spaur <jmsdarch@sbcglobal.net>
Subject: Re: [Healeys] fuel gauge calibration
From: Chris Dimmock <austin.healey@gmail.com>
Date: Fri, 8 Nov 2013 01:09:12 +1100
Cc: "healeys@autox.team.net" <healeys@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
References: <6.2.3.4.2.20131106221523.04ca46e0@pop.att.yahoo.com>
Hi John,
Before you head down the path of recalibrating your gauge, humor me.
Undo the sender unit from the tank, and lift it up a few inches. See if the
float at the bottom of the arm is resting at the rear of the car, or towards
the front.
(Optional: Now crawl under your car, and note that the curved 'sump' that the
float is supposed to sit in when the tank is empty, is at the front of the
car....)
Where is the float resting?
On the flat tank bottom, or in the curved lower 'sump'.
It should be in the sump.
There are a million sender units out there. All look the same - check
yours...
Float should be in the curved sump (at the front of the car) not on the flat
bottom of the tank.
Does the Gauge work now??
No?? Proceed with all the other advice.....

Sent from my iPhone

On 07/11/2013, at 5:27 PM, john spaur <jmsdarch@sbcglobal.net> wrote:

> There have been quite a few posts on this issue but none seem to really
solve the problem. When I first owned an Austin-Healey it was 6 years old and
the gauge was fairly accurate as I recall.
>
> The gauge on the healey was professionally calibrated but it was way off,
tending to stick at the full side and then rapidly dropping down to near
empty. Recently I calibrated it by removing the sender and adjusting the gauge
on the bench but it still sticks toward the full side. When the tank is below
1/2 it will start to read towards the 1/2 and 1/4 marks.
>
> What's the issue with getting the gauge to read more accurately? I think it
may have to do with the coils and magnet alignment. I think the coils may be
out of plumb (due to bending of the case at the nut attachment) which causes
the magnet to be too close to the armature assembly.
>
> Has anyone investigated this? Has anyone been able to get their gauge to
read more accurately?
>
> John Spaur
> '
_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


<Prev in Thread] Current Thread [Next in Thread>