The spring should always be at the oily/greasy side.
Kees Oudesluijs
Patrick & Caroline Quinn schreef op 8-6-2014 5:17:
> G'day Lin
>
> It faces the area which it's sealing against. So it faces the grease, so
> inside pointing towards the bearings.
>
> Hoo Roo
>
> Patrick Quinn
> Blue Mountains, Australia
>
> -----Original Message-----
> From: Healeys [mailto:healeys-bounces@autox.team.net] On Behalf Of Linwood
> Rose
> Sent: Saturday, 7 June 2014 9:36 AM
> To: healeylist
> Subject: [Healeys] Failing memory
>
> Front hub seals - spring to the inside or the outside?
> Thanks!
>
> Lin
> $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/p_cquinn@tpg.com.au
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2014.0.4592 / Virusdatabase: 3955/7645 - datum van uitgifte: 06/09/14
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|