Turn one flat is turn 360:6 flats=60 degrees. Flat is one side of the
nut/bolt. AF= Across Flats is an indication of a certain spanner size.
Kees Oudesluijs
NL
Mitch schreef op 5-7-2014 13:37:
> Hello,
> When adjusting carbs...............what does it mean by turn 1 flat?B B is it
> actuallyB 1/2 turn of the screw you are adjusting or one complete rotation?
> B
> sorry for the stupid question
> B
> Mitch
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/coudesluijs@chello.nl
>
>
>
> -----
> Geen virus gevonden in dit bericht.
> Gecontroleerd door AVG - www.avg.com
> Versie: 2014.0.4716 / Virusdatabase: 3986/7802 - datum van uitgifte: 07/05/14
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|