Simon, That is exactly how mine are. Original Healey tri carb manifolds
bored out to 1 3/4 for 3 HS6 carbs. A friend had a Hardinge lathe and
wanted a challenge so he made a bracket to hold each manifold and then bored
them out to 1 3/4 on center. Worked out great.
Randy
63 BJ7
60 BT7
-----Original Message-----
From: Healeys [mailto:healeys-bounces@autox.team.net] On Behalf Of Wilko2
Sent: Thursday, September 04, 2014 3:25 PM
To: Simon Lachlan
Cc: healeys@autox.team.net
Subject: Re: [Healeys] Rudd triples
Here's the set that I have. 1 3/4" carbs.
http://tinyurl.com/qfvuz2g
On Sep 4, 2014, at 12:26 PM, Simon Lachlan wrote:
> They passed the reserve to sell at #1060:00 (Pounds)! I was tempted,
> but
not
> that tempted!!
>
> The 1.5in manifolds from the MKII can be eased out to 1.75in to take
> HD or HS6s. Thats what I did, with advice from Bill Bolton. (But they
> wont go
to
> 2in).
>
> Simon
> _______________________________________________
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|