Actually I think Stephen right. Upon reflection slot head screws sounds more
familiar and difficult :-(
Michael S
BN1 #174
-----Original Message-----
From: "I Erbs" <eyera3000@gmail.com>
Sent: b9/b28/b2014 2:34 PM
To: "Stephen Hutchings" <s.hutchings@rogers.com>
Cc: "healeys@autox.team.net" <healeys@autox.team.net>
Subject: Re: [Healeys] heater valve
I have used one of these for tight spots
http://www.harborfreight.com/8-piece-right-angle-screwdriver-92630.html
Ira Erbs
Portland, OR
_______ _______
(______ \____1960 BT7____/ _______)
(_________________________)
On Sun, Sep 28, 2014 at 10:35 AM, <s.hutchings@rogers.com> wrote:
> I have to replace this item, but have been putting it off (bypassed the
> heater)
> However, I noticed Mike says that it's held on by hex head screws....I
> wish!
> Mine is held on by slot head screws...much harder to get ahold of.
> Think I'll have to drop the heater.
> Stephen BJ8
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/eyera3000@gmail.com
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
http://autox.team.net/mailman/options/healeys/michaelsalter@gmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|