Michael,
Have some that are stripped. Wondered about installing a threaded
insert to repair. I bought a new pedestal/bolt from Moss and was a bit
surprised to see that a non-standard thread was used and wondered if it
matched the original, or not. If not, then one would have to use a new
bolt with a new pedestal. The diameter of the threaded section of the
new banjo bolt is a bit larger than 3/8".
Cheers,
Bob Haskell
AHCA 3000 Mk I registrar
http://www.ciahc.org/registry_3000mk1.php
On 12/21/2014 10:15 AM, Michael wrote:
> Yep Bob,
> 3/8" x 28 TPI.
> Does beg the question...why?
> Michael S
> BN1 #174
> BTW. I have a tap for that...p
> ------------------------------------------------------------------------
> Sent: b21/b12/b2014 10:13 a.m.
> Subject: [Healeys] 6 cylinder rocker arm shaft pedestal
>
> Listers,
>
> The threaded hole in the rocker arm pedestal for the oil banjo bolt
> fitted to the 100 is 3/8 BSF. What's the thread for the 6 cylinder
> version? I would have thought 3/8 UNF or 3/8 BSC. The new part from
> Moss/AH Spares is something like 0.38-28.
>
> Cheers,
>
> Bob Haskell
> AHCA 3000 Mk I registrar
> http://www.ciahc.org/registry_3000mk1.php
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
>
> Healeys@autox.team.net
> http://autox.team.net/mailman/listinfo/healeys
>
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/healeys/michaelsalter@gmail.com
_______________________________________________
Archive: http://www.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
|