healeys
[Top] [All Lists]

Re: [Healeys] engine and piston question

To: "'Northside'" <nside@hiwaay.net>, <Healeys@autox.team.net>
Subject: Re: [Healeys] engine and piston question
From: Don Anglesey <healey100s@live.com>
Date: Fri, 9 Jan 2015 10:56:34 -0700
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
References: <54B00C0F.5000906@hiwaay.net>
Thread-index: AQABAgMEnZcoWNvFU5hrKv41Wg4i16BWZDPA
The 100-6 block should be a 1C/H.  When I changed pistons I also had to
change out rods because my 100-6 used clamp type which are impossible to
find.  If I was to do it again I would defiantly find a later 6-cyl block.
Don
57' BN4

-----Original Message-----
From: Healeys [mailto:healeys-bounces@autox.team.net] On Behalf Of Northside
Sent: Friday, January 09, 2015 10:13 AM
To: Healeys@autox.team.net
Subject: [Healeys] engine and piston question

I am rebuilding my100-6 BN4. I ordered a set of pistons. When they came in
the mechanic showed me they were too small. I have reached the conclusion
that the engine must have been swapped out at some point. The number on the
block is 29f/1H 5487. Can anyone tell from this # what the engine might be.
Thanks for any help.
Bud W
_______________________________________________

_______________________________________________
Archive: http://www.team.net/archive

Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys


<Prev in Thread] Current Thread [Next in Thread>