[Top] [All Lists]

Re: [Healeys] FW: BJ8 Bonnet/hood hinge removal and replace anti-rattle

To: Perry <healeyguy@aol.com> a=+Nz9qELIqCKR7yQQxiAklA==:17 a=kj9zAlcOel0A:10 a=3oc9M9_CAAAA:8 a=Glf3NOfYmVDPvRcDlrsA:9 a=CjuIK1q_8ugA:10 a=WQP3B-o2DcFb_-ao3AbR:22 reip=0.000, cl=1, cld=1, fgs=0
Subject: Re: [Healeys] FW: BJ8 Bonnet/hood hinge removal and replace anti-rattle washers
From: Rfbegani <rfbegani@speakeasy.net>
Date: Fri, 2 Dec 2016 08:31:48 -0700
Cc: healeys@autox.team.net
Delivered-to: mharc@autox.team.net
Delivered-to: healeys@autox.team.net
References: <17896294.2153210.1479329366056.JavaMail.root@vms170025.mailsrvcs.net> <2939EC99-5EBA-4F67-A4D6-491760D8A850@speakeasy.net> <B79A0EA6-8AF8-46D5-80CA-3C1E42B5213A@aol.com>
Thanks for the suggestion. Will try it. 

Sent from my iPhone

> On Dec 1, 2016, at 2:19 PM, Perry <healeyguy@aol.com> wrote:
> The factory installed the rubber buffers on the shroud lip so that the hood / 
> bonnet would have something to support it between the hinges and the front 
> latch. If you don't see a small mark on your bonnet paint were the buffers 
> are, chances are there is no support. Try laying a 1/16 inch thick piece or 
> rubber (old inner tube) on top of the buffer and close the bonnet. See if the 
> hood still shakes.  It may take two. When the buffers are  in contact the 
> bonnet will not shake side to side. Permanent solution is to properly install 
> the buffers. 
> Perry
> Sent from my iPhone

Archive: http://www.team.net/archive


<Prev in Thread] Current Thread [Next in Thread>