Bob, Is the adaptor for the spin-on filter on the correct way. That happened to
me. The holes do not line up correctly if upside down. Worth checking.
John Rowe Qld Australia
From: Healeys [mailto:healeys-bounces at autox.team.net] On Behalf Of Michael
MacLean
Sent: Wednesday, 4 July 2018 9:25 AM
To: Bob Haskell; Healey List
Subject: Re: [Healeys] no oil pressure
Check your gauge. Try putting a in line pressure gauge that is tested on your
oil system before you start taking things apart again.
Mike MacLean
On Tuesday, July 3, 2018 4:18 PM, Bob Haskell <rchaskell at earthlink.net>
wrote:
All,
Pulled the engine out of our tri-carb last December due to low oil
pressure and running too hot. Bearings were okay; the engine got a new
oil pump, rear main seal, pressure relief spring and plunger, and timing
gears, chain and tensioner.
Started the engine yesterday and it started almost immediately. So I
was really pleased until I looked at the oil pressure gauge and saw the
needle was sitting on the peg. No oil visible at the rocker arms either.
I removed the spin on oil filter and attempted to prime the oil pump by
squirting oil the filter inlet passage. But it was already full.
Can one remove the distributor and spin the oil pump with a drill motor?
I'd like to be able to test without spinning the crank and cam on dry
bearings, etc..
Suggestions?
Cheers,
Bob Haskell
AHCA 3000 MkI registrar
http://www.ciahc.org/registry_3000mk1.php
_______________________________________________
Archive: http://www.team.net/pipermail/healeys
Healeys at autox.team.net
http://autox.team.net/mailman/listinfo/healeys
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://autox.team.net/pipermail/healeys/attachments/20180704/c10cdadf/attachment.html>
|