Someone please correct me if I'm wrong, but I believe that the bolt seen
on the left hand side of the pump would be removed and a grease fitting
installed to grease the pump.
Cheers,
Bob Haskell
Austin Healey 3000 BN7/BT7 registrar
On 9/17/20 7:38 AM, Michael Oritt via Healeys wrote:
> Steven--
>
> If by "open" you mean the long oblong hole the answer is yes--whether
> or not by design it is a sort of early warning system of seal
> failure as water getting past the seal will drip from it.
>
> Best--Michael Oritt
>
> On Wed, Sep 16, 2020 at 5:00 PM Steven Kingsbury via Healeys
> <healeys@autox.team.net <mailto:healeys@autox.team.net>> wrote:
>
> Â Â Â I am in the process of putting my engine back together and upon
> cleaning the water pump, I found the bottom of the pump to be
> thick with what appeared to be grease. As I cleaned the grease
> away I found a hole at the bottom of the housing. Is this normal?
> I have a 1955 BN1 and I have to admit, I have never looked at the
> bottom of a 100 water pump.
> Â Â Â Was there once a grease fitting there? Are all of them open
> like this? I'm cleaning it to repaint and reinstall, but I'm a bit
> concerned and need the wisdom of the list to relieve my tension.
> Â Â Â Thanks in advance guys,
> Steven Kingsbury
> BN1
>
>
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
Unsubscribe/Manage:
http://autox.team.net/mailman/options/healeys/mharc@autox.team.net
|