--===============1944524203891360512==
--00000000000079484e05bc5de3b8
All -
One of the three holes at the bottom of my exhaust header is loose and the
stud doesn't seat properly (but it does screw in).
I was thinking of putting some "thermosteel" or JB "extreme heat" in there
then tapping it out.
The threads are still there and it just needs a bit of fill to tighten it
up.
Has anyone ever done a similar repair? Will it last?
Alan
--00000000000079484e05bc5de3b8
Content-Transfer-Encoding: quoted-printable
<div dir=3D"ltr">All -<div><br></div><div>One of the three holes at the bot=
tom of my exhaust=C2=A0header is loose and the stud doesn't seat proper=
ly (but it does screw in).=C2=A0</div><div><br></div><div>I was thinking of=
putting some "thermosteel" or JB "extreme heat" in the=
re then tapping it out.=C2=A0=C2=A0</div><div><br></div><div>The threads ar=
e still there and it just needs a bit of fill to tighten it up.</div><div><=
br></div><div>Has anyone ever done a similar repair?=C2=A0 Will it last?</d=
iv><div><br></div><div>Alan</div></div>
--00000000000079484e05bc5de3b8--
--===============1944524203891360512==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Archive: http://www.team.net/pipermail/healeys http://autox.team.net/archive
Healeys@autox.team.net
http://autox.team.net/mailman/listinfo/healeys
--===============1944524203891360512==--
|