land-speed
[Top] [All Lists]

RE: Al-Jazeera News

To: Dale.Clay@mdhelicopters.com
Subject: RE: Al-Jazeera News
From: Ed Van Scoy <ed@vetteracing.com>
Date: Tue, 25 Mar 2003 09:49:57 -0700
This is an example of bad deeds done for good reason....
Yesterday hackers shut down this site because it was too
disgusting. 
Ed

---- Original message ----
>Date: Tue, 25 Mar 2003 08:24:40 -0700
>From: <Dale.Clay@mdhelicopters.com>  
>Subject: RE: Al-Jazeera News  
>To: <jimbelford@msn.com>, <land-speed@autox.team.net>
>
>Couldn't get it to open, which is probably a good thing.  I'm
waiting for
>some condemnation from the UN ... still waiting ... (crickets
chirping).
>
>Dale C.
>               
>               Subject:        Al-Jazeera News
>
>               Here is a link to the photos of american POWs that they have
>been discussing 
>               on CNN but cannot show.
>               Warning they are graphic.
>
>               http://www.aljazeera.net/news/arabic/2003/3/3-23-23.htm
>
>               I beleve they should show them just to reinforce that we are
>dealing with 
>               barbaric assholes they could care less about the Geneva
>Convention.
>
>
>
>
>               
>
>----------------------------------------------------------------------------
>The information transmitted is intended only for the person
or entity to 
>which it is addressed and may contain confidential and/or
privileged 
>material.  Any review, retransmission, dissemination or other
use of, or 
>taking of any action in reliance upon, this information by
persons or 
>entities other than the intended recipient or employees of 
>MD Helicopters, Inc. is prohibited.   If you received this in
error, please
>contact the sender by email and delete the material from any
computer.

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/land-speed
///  what is needed.  It isn't that difficult, folks.


<Prev in Thread] Current Thread [Next in Thread>