I guess that's two of us that have a crew chief that also knows the inner
workings of a Singer......
Ed V
-----Original Message-----
From: neil@dbelltech.com [mailto:neil@dbelltech.com]
Sent: Saturday, February 21, 2009 06:46 PM
To: drmayf@mayfco.com, ''Benn''
Cc: land-speed@autox.team.net
Subject: Re: [Land-speed] Heat Protection
Mayf; Your crew chief is a keeper! Regards, Neil Tucson, AZ -----Original
Message----- From: land-speed-bounces@autox.team.net
[mailto:land-speed-bounces@autox.team.net] On Behalf Of drmayf Sent: Saturday,
February 21, 2009 6:38 PM To: Benn Cc: land-speed@autox.team.net Subject: Re:
[Land-speed] Heat Protection Guys, thanks for all the possible solutions. I
think I have one that is good enough. I am just gonna fold over a piece of
header wrap material, have the crew chief sew it closed on the open side,
slide my tubing into it and be done with it. Many thanks, mayf Benn wrote: > I
don't think that foam stuff for pipes is gonna have sufficient > high-temp and
radiation resistance--might even be rather flamable. > I'd guess the subject
lines go near the exhaust, perhaps? You then > need radiation shielding as
much as or more than insulation. So I'd > be thinking metal (with some sort of
liner/spacer just to keep the > metal out of contact with the line). > Benn >
> ----- Original Message ----- From: "Elon" > To: "land-speed submit" > Sent:
Saturday, February 21, 2009 4:46 PM > Subject: [Land-speed] Heat Protection >
> >> Local hardware store for the stuff used to keep your water pipes from >>
freezing. Or lay it in a tray and pour the 2-part foam in a can used for >>
home insulation if a rigid line is ok. >> >> >> >> From: drmayf >> >> . . . My
water injection line is 1/4 od high quality air line. I >> would like >> some
suggestions for sliding something over it to gie it some heat >> protection.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Land-speed mailing list
http://autox.team.net/mailman/listinfo/land-speed
|