----- Original Message -----
From: "Bud Krueger" <budkrueger@earthlink.net>
To: "mg-t" <mg-t@Autox.Team.Net>
Sent: Thursday, December 23, 2004 6:19 PM
Subject: My TD Mods
> Cooling system: I have added an overflow recovery tank from an MGB. The
> purpose is to avoid the loss of coolant that occurs at cruising speeds
> when coolant gets into the overflow pipe and gets sucked out into the air
> stream under the car. It comes back up through the engine compartment and
> out through the louvers to make a mess on the bonnet and fenders. This
> bit of plumbing (easily removable) eliminates the loss and the mess.
> http://home.earthlink.net/~budkrueger/Overflow_tank.html
Thanks Bud, it's been driving my crazy trying to figure out what's been
messing up my louvers!
Bob Donahue (Still Stuck in the '50s)
Email - bobmgtd@insightbb.com
Cars: 52 MGTD - #17639
71 MGB - #GHN5UB254361
Member: NEMGTR #11470
NAMGBR # 7-3336
Hoosier MGB Club
Olde Octagons of Indiana
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/mg-t
|