mg-t
[Top] [All Lists]

[Mg-t] TD front axle

To: mg-t@autox.team.net, mgs@autox.team.net
Subject: [Mg-t] TD front axle
From: Mike Duvall <duvallcom@sbcglobal.net>
Date: Mon, 25 May 2009 16:28:54 -0500
I discovered my TD 2541 has a big washer between the bearing and nut  
and no grease hub cap.  I discovered the washer rides up onto the  
bearing and the washer wears and causes heat.

I looked in the mg manual and it shows (section I figure 1.2) a felt  
washer, grease retaining washer and nut. and section K.16 talks about  
a service kit for cars without a hub to stop grease leakage.  I don't  
understand how a felt washer would let you torque the nut properly.

Moss shows washer and nut with grease cap.

I'm assuming my best path would be to torque the nut and then try to  
find a way to seal the hub or just keep it clean.   Anybody else have  
a better idea or know a different solution?  I'm also assuming moss's  
grease cap won't fit the early car.

Thanks,  Mike
_______________________________________________

Support Team.Net  http://www.team.net/donate.html

Mg-t@autox.team.net
http://autox.team.net/mailman/listinfo/mg-t

Archives at http://www.team.net/archive

<Prev in Thread] Current Thread [Next in Thread>