Re: [Mg-t] Mg-t Digest, Vol 7, Issue 102

[Glenn Schnittke <g.schnittke@comcast.net>]

Yeah... glue would work, but hard to get off. Race tape is better. It'll 
come off.  But if you know it's going to take a while, POR-15 will stick 
to anything.

I found that fixing the stand to the front of the block allowed me to 
get the rear taken apart quite easily, and then it's a combination of 
bench and, yes, four 8mm bolts at the rear.

It's not a heavy block. At half my age I could lift it loaded. Hmm. 
Maybe I shouldn't have said it that way.

Glenn


On 7/14/2013 6:36 PM, mg-t-request@autox.team.net wrote:
> Subject: Re: [Mg-t] Engine stand + XPAG
> Message-ID:<502E0C10-05D9-483C-91F2-E4022B2985E5@ghs.com.au>
> Content-Type: text/plain; charset=us-ascii
>
> I'd use bolts, but if you're feeling lucky try glue........
>
> Murray Arundell
>
> On 15/07/2013, at 2:32 AM, Rick Lindsay<richardolindsay@gmail.com>  wrote:
>
>> >Hi Friends,
>> >
>> >What is the preferred method of mounting an XPAG on an engine stand?
>> >
>> >-rick
>> >Sent from my Samsung Galaxy SIII - the rectangle with rounded corners, just
> like a BlackBerry.
______________________________________________

Mg-t@autox.team.net
Archive: http://www.team.net/archive