| To: | mgb-v8@autox.team.net |
|---|---|
| Subject: | RE: Replacing the Seal on bottom of Windshield assembly |
| From: | "Robicheau, Mike" <MRobicheau@philipinc.com> |
| Date: | Mon, 10 Jul 2000 08:31:54 -0400 |
| Reply-to: | "Robicheau, Mike" <MRobicheau@philipinc.com> |
| Sender: | owner-mgb-v8@autox.team.net |
awulf@bewellnet.com wrote:Is there an easy way to replace
the seal
(Moss Part no. 282-410)page 69 of the MGB catalog?
I installed seal with a ¼ inch rope under the curl then
pulled it out after , when pulled out it uncurled the seal. Good luck
|
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Rear end ratios, Larry Hoy |
|---|---|
| Next by Date: | Re: Rear end ratios, Allen Wulf |
| Previous by Thread: | Re: Replacing the Seal on bottom of Windshield assembly, renaud |
| Next by Thread: | Looking for Rover engine?, Barrie Robinson |
| Indexes: | [Date] [Thread] [Top] [All Lists] |