| To: | Bruce <brucemills@dccnet.com> |
|---|---|
| Subject: | Re: Tranmission Tunnel |
| From: | Jim Stuart <jimbb88@erols.com> |
| Date: | Sat, 09 Dec 2000 00:33:12 -0500 |
| Cc: | mgb-v8@autox.team.net |
| References: | <002b01c0619f$a3963b40$969e05d1@bruce> |
| Reply-to: | Jim Stuart <jimbb88@erols.com> |
| Sender: | owner-mgb-v8@autox.team.net |
Just enough so the transmission clears. Santa Bruce wrote: > With regards to my 74 1/2 MGB/Rover 3.5/Camero T5 tranny/MGB conversion. I > have beaten up the transmission tunnel so that the front tranny seam is on a > higher plane than the next structural member. Which is the one where the > radio structural support is directly above. The question I have is how much > does the seam have to be beaten up to fit the T5? > > Thanks in advance > > Bruce |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Tranmission Tunnel, Bruce |
|---|---|
| Next by Date: | Re: Tranmission Tunnel, J MILLER |
| Previous by Thread: | Tranmission Tunnel, Bruce |
| Next by Thread: | Re: Tranmission Tunnel, Jim Stuart |
| Indexes: | [Date] [Thread] [Top] [All Lists] |