>Which brings to mind a car question. If you have the main bearing caps
>line bored (should that be "align bored"?) as Denise suggests, does that
>enlarge the bearing holes? What do you do then? Are bearings made for
>oversize caps?
They first shave the bottom of the bearing caps (and the block too?), so
when they bore the holes again they come out to the original size and
location. Otherwise you'd need shells with an oversize OD. sf
Stan Fickes If you want safe speed--buy safe speed--MG.
Wireless communications 1951 MGTD, under restoration
Apple Computer, Inc. 1965 Sprite, daily commuter
(408) 974-7653 1957 Bel Air StWgn, wife's car
|